How to Measure Your Roofline for Christmas Lights (No Ladder Needed)

You don’t need to climb on the roof to measure it for Christmas lights. Installers measure most houses from the driveway or from a photo. Here is how to do it, whether you’re hanging lights yourself or getting quotes.

Short answer: Take a straight-on photo of the house, use the garage door (usually 16 feet wide) as your scale, measure each roofline section, add them up and add about 10% for peaks, drops and the run to the outlet.

Measuring a roofline from a photo for Christmas lights

How do I measure my roofline from the ground?

Short answer: Walk it. Pace the length of the house along the gutter line, then estimate each gable and peak by eye or from a photo.

  1. Measure the straight runs. Walk the front of the house with a measuring wheel or count your steps (most adult steps are about 2.5 feet).
  2. Add the gables. Each sloped side of a peak is longer than it looks. A typical front gable adds 25 to 35 feet.
  3. Add the drops. Wherever the lights go down a corner or between levels, add that height.
  4. Add the lead. Measure from the outlet to where the lights start. That part is extension wire, not lights, but you need to buy it.

How do I measure a roofline from a photo?

Short answer: Use something with a known size as a ruler. A two-car garage door is almost always 16 feet wide.

Stand straight in front of the house and take the photo from the street. Then mark the garage door as 16 feet and trace the roofline. The free Christmas Light Calculator does this for you: set the scale, tap along the roofline, and it adds up the feet and shows the lights on your house.

Installers can do the same in the Christmas Light Estimator, which turns the feet straight into a quote and a material list.

How long is a typical roofline?

Part of the house Typical length
Two-car garage front 16 to 30 ft
Front gable (both sides) 25 to 35 ft
One-story home, front only 100 to 200 ft
Two-story home, front only 150 to 300 ft

How many feet of lights should I buy?

Short answer: Buy your measured roofline plus about 10%. With commercial socket wire you cut it to fit, so extra wire is not wasted.

Then work out the bulbs: at 12-inch spacing you need one C9 bulb per foot, at 15-inch spacing about 0.8 per foot. Our guide to how many C9 bulbs you need has the full chart.

Lighting more than one house? A 1,000 ft Christmas light kit covers about 5 to 10 average rooflines.

Christmas light installer on a ladder hanging roofline lights

Should I hire a pro instead?

If the roofline is two stories or steep, it is worth it. Pros carry the ladders, insurance and commercial lights, and they take everything down in January. Find Christmas light installers near you and send them your measurements and a photo for a faster quote.

ChristmasPlug Team
Author: ChristmasPlug Team

The ChristmasPlug team: Christmas light installers with nine years in the trade.

Written by the ChristmasPlug team
Our team has installed Christmas lights for nine years, from single-story rooflines to large HOA and commercial displays. About ChristmasPlug

Refunds & cancellation · GOAT Verified